| The cutting needle VENERE is a new revolutionary
system in the embroidery industry, which allows every cut,
namely every incision to be made directly on the embroidery
machine. |
| The installation of four needles on a machine,
as show in the picture, permits every kind of cut. The system
consists of 4 cutting needles, which replace the regular embroidery
needles. They are installed at an angle of 45° to each
other (0° - 45° - 90° - 135°). Simple forms
such as rectangles, rhombi, squares, etc. requires only two
needles for cutting. However, with all four needles, every
kind of complex forms can be archived. The use of these does
not require any change in the machine. The only need is two
switch off the "thread break" sensor. |
| To achieve this function, a running stitch which
runs parallel to the embroidery must be inserted in the existing
design. Its stitch length should not exceed 1mm. The cutting
needle has width of 1,2mm. The cutting can be programmed independently,
either before or after the embroidery. This novelty enables
the embroidery companies to create special artwork in different
branches with a higher quality, shorter production time and
lower costs. |
