 |
|
|
|
|
|
|
|
|
|
|
|
 |
|
||||||||||
 |
 |
 |
|
||||||||
 |
 |
 |
 |
 |
 |
 |
|
||||
 |
 |
 |
|
||||||||
 |
|
||||||||||
 |
 |
 |
|
||||||||
 |
|
||||||||||
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| Satin serial module™ parameters: | ||||||||
 |
||||||||
|
Satin serial parameters for existing punching objects: | |||||||
 |
||||||||
| With satin serial stitch type you can add a punching object of satin stitches. In this case, a smooth curve connects the nodes that you are adding. The most important thing in using satin serial is that you have to add a single curve made of nodes and the program creates a satin bar with constant width, following the curve you have punched. | ||||||||
| The parameters that you can change in this type of punching are: | ||||||||
|
||||||||
|
Random width: | |||||||
| With this parameter you can specify the random width percentage of Satin serial. Using this parameter, the length of Satin serial stitches will be between the width of the outline and the width of the outline minus the percentage that you have specified. | ||||||||
|
Direction of the random: | |||||||
| With these three icons you can specify whether the random stitches will be from both sides or which side they will be from. The choices that you have for random are | ||||||||
|
||||||||
|
Half-pitch compensation: | |||||||
| In case that this logical parameter is set as Yes the program will start placing the stitches after a half of thread thickness. | ||||||||
|
Short/Long: | |||||||
| In this logical parameter you can activate or disable sort/long stitches to the current object. The sort/long stitches are needed in case that there is steep change of direction of satin and there are not curve break nodes on the outline. | ||||||||
|
The offset of the satin serial: | |||||||
| In this parameter you can specify the distance of the punched curve from the center of the satin serial. this tool is very useful in case that the satin serial is a border of another object | ||||||||
